Home » Technical Features » Test

The quality of Iberruedas products is guaranteed by in-house testing procedures that include acceptance checks of incoming raw materials and all other purchased components, checks performed on intermediate products in the various stages of the production process, and testing of finished products.

The TR Lab is equipped with test rigs and equipment to allow in-house testing in compliance with international standards in the wheels and castors sector and also in relation to specific application sectors.

Specifically:

• Dynamic load testing of castors and wheels for industrial applications in compliance with ISO 22883:2004 or ISO 22884:2004;

• Dynamic load testing of castors and wheels for mobile waste containers in compliance with BS EN 840-5:2004;

• Dynamic load testing of castors and wheels for institutional applications in compliance with ISO 22881:2004;

• Conformity tests of scaffolding castors and wheels in compliance with UNI EN 1004:2005

• Rollability tests on castors and wheels for industrial applications in compliance with UNI 11330;

• Efficiency checks of wheel braking and/or locking device in compliance with ISO 22883:2004 or ISO 22884:2004;

• Static load capacity tests of wheels for institutional applications in compliance with ISO 22881:2004

The following chart describes the tests carried out in compliance with the applicable standards for determination of the load capacity stated in the catalogue for wheels for industrial applications:

Industrial wheels
Manually propelled equipment

Industrial wheels
Power towed equipment

Standard

ISO 22883:2004

ISO 22884:2004

Test load

Nominal capacity

Nominal capacity

Test speed

4 km/h

A = 6 km/h; B = 10 km/h; C = 16 km/h

Ambient temperature

From 15 to 28 °C

From 15 to 28 °C

Flooring

Hard floor with obstacles

Hard floor with obstacles

Height of obstacles

5% of wheel diameter for elastic rolling strip (<= 90 Sh A); 5.5% of wheel diameter for rigid rolling strip (hardness > 90 Sh A)

5% of wheel diameter for elastic rolling strip (<= 90 Sh A); 5.5% of wheel diameter for rigid rolling strip (hardness > 90 Sh A)

Obstacles layout

Width 100 mm; rounded corners with radius between 1.5 and 5 mm and arranged at 45° with respect to the axis of translation, alternately on the right and on the left

Width 100 mm; corners with radius between 1.5 and 5 mm and arranged at 45° with respect to the axis of translation, alternately on the right and on the left

Obstacles quantity

500 obstacles spaced at between 1 and 3 metres

5 times wheel diameter in mm (e.g. a 200 mm dia. wheel must pass 1,000 obstacles); the obstacles are spaced as follows: A>= 1 m; B>= 1.5 m; C>=3 m

Duration

Sequence of cycles with maximum duration of 3 min. and maximum pause time of 1 min. The wheel must pass the obstacles and then complete 15000 revolutions without obstacles

Sequence of cycles with a maximum duration of 3 min. and maximum pause time of 1 min. The wheel must pass all the obstacles.

Contact Iberruedas for any further information required.